Characteristics and processing technology of wood veneer

Trim panel , is generally cut into a sheet of natural wood, plywood with an adhesive adhered to the surface normal, the decorative metallic hot processed, which has the following characteristics:

1. Has good durability. Wooden veneer has better compressive strength and abrasion performance, and its durability is much higher than other man-made veneers.

2. High stability; wooden veneer veneer, avoiding common deformation and knotting.

3. The natural long-haired wooden veneer retains the natural properties and luster of the wood, has a special charm and natural luster, and has a good surface touch.

4. Break the limitations of solid wood. The wood veneer can be cut casually, breaking the limitation of the size and texture of the wood veneer, and can make the wood veneer more complete and the pattern more regular.

5. Save wood resources. The wooden veneer makes full use of wood resources and adopts plywood and veneer to reduce production costs and is very cost-effective.

6. Green and environment-friendly wooden veneer chooses asbestos base material and natural veneer that meet the national E1 environmental protection standard, which can meet the requirements of green and environment-friendly.

Wood veneer panel processing technology.

1. Select the watch face. According to user requirements, choose the appropriate thickness and quality of the surface board, the whole board does not overlap, do not separate from the seam, and there is no serious color difference, wrinkles, wrinkles, wrinkles, and no adhesion.

2. Substrate finishing and sanding. Fill up the cavities, grooves, overlapping grooves, surface garbage, surface and inside garbage on the substrate. Side-repair and side-division, stacking defective products such as large chip, large chip, degumming, and breakage separately. Polish the finished bottom plate with fine sand. The sanding belt is generally 150 mesh and 180 mesh. The surface of the polished board is smooth and clean, without dents, dents, sand leakage, head collapse, sand jumping, and pollution.

3. The substrate is dry. Color the sanded substrate evenly, and then enter the drying room to dry, after controlling the moisture content ≤14%, the veneer can be carried out.

4. The veneer bottom board is glued and veneered. There is no sawdust, glue marks, etc. on the surface of the board, and no seam.